Custom printer with center of bed at 0,0 results in "toolpath outside print area" #3510
The G92 A0 B0 was incorrectly considered to be equal to just G92
to reset all axes.
Fixes Connecting / expanding Bottom Layers to Vase Perimeter #253
Fixes Slicing error in vase mode #452
Fixes Slicing Issue (Vase Mode, 0.6mm dmr nozzle) #1887
Fixes Top fill pattern isn't used in spiral vase mode #2533
Fixes Cisar's vase doesn't slice correctly, creates artefacts #3595
When the model is sliced, all the contours are newly oriented
counter-clockwise (even holes), merged and then only the largest area
contour is retained. In perimeter generator, if the largest contour
splits into multiple perimeters, newly only the largest area perimeter
is retained in spiral vase mode. These two changes solve #3595 and similar.
The infill is newly calculated only for the bottom solid layers
if the spiral vase mode is active (removes various unwanted infill
along the vase walls), and the last bottom solid layer is switched
to a top solid pattern (solves #2533).
The thin walls are newly enforced to be disabled in spiral vase mode,
and the "ensure vertical shell wall" is enforced in spiral vase mode
to extend the bottom of the vase to the vase hull (fixes#253).
printer configuration:
ss -> sm : Just apply the color changes of the original ss project at the active extruder.
ss -> mm : There are no tool changes stored. Ignore color changes, they are invalid because they are extruder non-specific.
sm -> ss : Apply tool changes as color changes (tool changes remember the target color), apply original color changes.
sm -> mm : Ignore both color changes and tool changes.
mm -> ss/sm : Ignore both color changes and tool changes.
so that the ordering code at G-code export may work directly with
pointers to PrintInstances instead of with pair of <PrintObject, copy idx>.
Also the PrintInstance knows its source ModelInstance, which allows
sorting of PrintInstances for sequential printing in the order
they appear in Plater's object list.
psWipeTower now equals to new psToolOrdering indicating that
the ToolOrdering has been calculated (only if non-sequential mode is active).
psBrim now equals to new psExtrusionPaths
psExtrusionPaths shall be the last step before psWipeTower, indicating
that all the printing extrusions are calculated for the G-code preview
slider to edit the custom per print_z color changes, tool changes etc.
Refactoring of GCode export of color changes, extruder switches etc,
so that the "color change" like extruder switches are applied first
at the Wipe Tower / G-code export, so that adding / removing
an extruder switch at the G-code preview slider does not invalidate
slicing.
