1) Slic3r::RuntimeError was replaced with ConfigurationError,
all exceptions thrown by the configuration layer are derived
from ConfigurationError.
2) When parsing configuration files, ConfigurationError is catched and
rethrown extended with the file name being parsed.
config bundles, project files (3MFs, AMFs). When loading these files,
the caller may decide whether to substitute some of the configuration
values the current PrusaSlicer version does not understand with
some reasonable default value, and whether to report it. If substitution
is disabled, an exception is being thrown as before this commit.
If substitution is enabled, list of substitutions is returned by the
API to be presented to the user. This allows us to introduce for example
new firmware flavor key in PrusaSlicer 2.4 while letting PrusaSlicer
2.3.2 to fall back to some default and to report it to the user.
When slicing from command line, substutions are performed by default
and reported into the console, however substitutions may be either
disabled or made silent with the new "config-compatibility" command
line option.
Substitute enums and bools only. Allow booleans to be parsed as
true: "1", "enabled", "on" case insensitive
false: "0", "disabled", "off" case insensitive
This will allow us in the future for example to switch the draft_shield
boolean to an enum with the following values: "disabled" / "enabled" / "limited".
Added "enum_bitmask.hpp" - support for type safe sets of options.
See for example PresetBundle::load_configbundle(...
LoadConfigBundleAttributes flags) for an example of intended usage.
WIP: GUI for reporting the list of config substitutions needs to be
implemented by @YuSanka.
WIP: MutablePolygon - linked list based polygon implementation
allowing rapid insertion and removal of points.
WIP: porting smooth_outward() from Cura.
Working contour offsetting,
skeleton_edges_rough() to detect "important" skeleton edges.
Radius of an inscribed circle along the "important" skeleton edges
changes slowly, therefore these "important" skeleton edges signify
oblong regions possibly needing a gap fill.
limited anchors, while before a full perimeter segment was always
taken if possible.
2) Adapted the line infills (grid, stars, triangles, cubic) to 1).
This also solves a long standing issue of these infills producing
anchors for each sweep direction independently, thus possibly
overlapping and overextruding, which was quite detrimental
in narrow areas.
3) Refactored cubic adaptive infill anchroing algorithm
for performance and clarity.
