Missed adding [total_layer_count] to layer_gcode
Revert "Add new [total_layer_count] placeholder everywhere [layer_num] is avalible."
This reverts commit e29e766224a14e1f237908c3e5507ac5586ca5b7.
Revert "Missed adding [total_layer_count] to layer_gcode"
This reverts commit f07907a8acc450e9ae1220c6a9fe4f7c7e6d896c.
Better way to add [total_layer_count]
has been rewritten to be easier to parse.
Old format
; filament used = 19248.8mm (46.3cm3)
; filament used = 57.4
; filament cost = 1.5
; filament used = 8007.6mm (19.3cm3)
; filament used = 23.9
; filament cost = 0.6
; filament used = 0.0mm (0.0cm3)
; filament used = 0.0mm (0.0cm3)
; filament used = 0.0mm (0.0cm3)
; total filament cost = 2.1
New format
; filament used [mm] = 1600.7,1600.7,1600.7,1600.7,1600.7
; filament used [cm3] = 3.9,3.9,3.9,3.9,3.9
; filament used [g] = 4.8,4.8,4.8,4.8,4.8
; filament cost = 1.5,1.5,1.5,1.5,1.5
; total filament used [g] = 24.0
; total filament cost = 7.5
Where the non-printing extruders are filled in with zeros, and
the trailing non-printing extruders are not exported.
; filament used [g]
and
; filament cost
are only printed if non zero (material density and cost are defined)
from the current Model/ModelObjects.
Fixed a possible race condition in updating Print::m_placeholder_parser
with the proposed filename / filename base.
Improved documentation (source code comments).
This is a fix of a long standing bug, where an extrusion is incorrectly
drawn from the end of the last wipe move. Interestingly enough,
this bug is in Slic3r at least since 1.2.9, but lucky enough
it only occured for single perimeter, no infill prints with wipe after
retract enabled, and only if the two successive slices were discretized
exactly the same, which is quite unlikely.
by PrintObject::region_volumes. This is due to the way Print::apply()
works, it does not invalidate an existing PrintObject if a new region
is added to the print.
