Reduce the size of current and new JSONs by standardising them with 1 tab indentation instead of 4 spaces.
This effectively reduces the size by almost 20 MB.
| Current | New |
|---|---|
| 85.2 Mib | 67 Mib |
Used [JQ](https://jqlang.org/) `--tab` to automatically format every current JSON.
> [!NOTE]
> Some profiles had the arrays on the same line, but those created by Orca were in the standard format (each object below the previous one). In some cases, this increases the number of tabs due to the new lines, but the increase is negligible, and this way both the base profiles and those created by Orca maintain the same style.
Previously, wipe tower behavior was determined by checking if the printer
was a QIDI vendor. This introduces a configurable enum (Type 1 / Type 2)
so any printer can select its wipe tower implementation. BBL printers
remain hardcoded to Type 1. Qidi profiles default to Type 1.
* 10-25
Add TPU-95A HF
* 1030
Adding Introduction of Chamber Temperature Control Macros(M191) to Notes
* 1102
Add ABS-GF10 profile，
Remove a extra "s" from the "0.36mm Standard @Qidi XPlus3 0.6 nozzle.json" file
* 1106
Add the PA value to some genetic filament profiles
* Add new filaments profiles
Add new filaments profiles
* 1
1
* Add two new filaments
Add two new filaments
* Optimized 0.2mm nozzle profiles
Optimized 0.2 mm nozzle QIDI Generic ABS/PETG/PLA profiles
* disable prime tower
disable prime tower and independent_support_layer_height,
Improve some part of the surface when supported
* Fix the name issue
Fix the name issue
* 10-25
Add TPU-95A HF
* 1030
Adding Introduction of Chamber Temperature Control Macros(M191) to Notes
* 1102
Add ABS-GF10 profile，
Remove a extra "s" from the "0.36mm Standard @Qidi XPlus3 0.6 nozzle.json" file
* 1106
Add the PA value to some genetic filament profiles
* Add new filaments profiles
Add new filaments profiles
* 1
1
* Add two new filaments
Add two new filaments
* 10-25
Add TPU-95A HF
* 1030
Adding Introduction of Chamber Temperature Control Macros(M191) to Notes
* 1102
Add ABS-GF10 profile，
Remove a extra "s" from the "0.36mm Standard @Qidi XPlus3 0.6 nozzle.json" file
