forked from viewit/OrcaSlicer-KX
a815bef42c
* Remember z of previous layer * Support travel to middle of the layer z * Support sloped extrusion * Implement sloped seam * Reduce extra movements * Don't clip loop if sloped seam is enabled * Fix wipe * Ensure `slope_max_segment_length` * Add options * Limit slope length to perimeter length * Fix slope segmentation * Rename the option to scarf joint seam * Don't modify the slope option when turning on spiral vase * Add a few suggestions when turnning on scarf joint * Add option to add scarf joint to inner walls * Apply seam gap at the end of the slope * Add option to explicitly use the entire loop as scarf length * Fix layer number * Increase default scarf length to 20mm * Better way of storing the global scarf state * Better vase mode layer height recognition * Move id should exclude seams * Fix slope height with independent support layer height * Fix linux build * Allow controlling the scarf with modifier * Scarf start height default to 0 * Allow enable scarf seam on contour only * Fix type error * Move the creation of sloped loop into ExtrusionEntity.cpp * Fix error "vector too long" * Detect seams properly * The correct way of calculating the rate limit * The correct way of calculating the rate limit (cherry picked from commit 05961f7c98803a42871b8df855bfff6a102936c4) * Add pressure equalizer in print by object mode * Remove the settings recommendation as it varies a lot depends on printer & filament * Add a beta suffix --------- Co-authored-by: SoftFever <softfeverever@gmail.com>