This was broken between 2.2.0 and 2.3.0. The 'entering' snapshot
should be taken before the gizmo opens, not after. Otherwise it is
in fact the same as the next snapshot.
This is a regression to a late PrusaSlicer 2.4.0-alpha0 change
8dfc0422a8
Faster and hopefully more reliable projection of paint-on support
blockers and enforcers on a sliced mesh.
Previous d89f01c717 did not fix it.
This is a regression to a late PrusaSlicer 2.4.0-alpha0 change
8dfc0422a8
Faster and hopefully more reliable projection of paint-on support
blockers and enforcers on a sliced mesh.
../src/libslic3r/QuadricEdgeCollapse.cpp:628:21: warning: comparison of integer expressions of different signedness: 'const int' and 'uint32_t' {aka 'unsigned int'} [-Wsign-compare]
../src/libslic3r/QuadricEdgeCollapse.cpp:631:21: warning: comparison of integer expressions of different signedness: 'const int' and 'uint32_t' {aka 'unsigned int'} [-Wsign-compare]
../src/libslic3r/QuadricEdgeCollapse.cpp:638:48: warning: comparison of integer expressions of different signedness: 'const int' and 'uint32_t' {aka 'unsigned int'} [-Wsign-compare]
../src/libslic3r/QuadricEdgeCollapse.cpp:643:25: warning: comparison of integer expressions of different signedness: 'const int' and 'uint32_t' {aka 'unsigned int'} [-Wsign-compare]
../src/libslic3r/QuadricEdgeCollapse.cpp:647:25: warning: comparison of integer expressions of different signedness: 'const int' and 'uint32_t' {aka 'unsigned int'} [-Wsign-compare]
1) Activate installed filament or SLA material profile after update_compatible(),
so that the compatiblity and visibility flags of presets are updated.
2) Only activate the first newly installed filament / SLA material profile
if the active printer did not change. This also means that if no filament
profile was active before Wizard was open or it became incompatible with
the newly installed Printer profile, the default filament profile assigned
to the activated Printer is activated preferably, which may or may not
be one of the newly installed filament profiles.
object layer over raft interface:
"first_layer_speed_over_raft", "first_layer_acceleration_over_raft".
Fixes I have a question about the speed of the first layer after the raft. #6623
Fixes Layer After Raft Is Not Considered First Layer! #6166
